Wood Preservative Gel (Eco Bor II)  

Formulated to treat deeper section, structural beams and joists Ecobor 20 is the essential companion product to our Woodzone range. Ecobor 20 is a special boron-based, brushable & injectable gel for use to treat against dry and wet rot as well as wood destroying insects. It has been developed to penetrate deeply into all timbers at high risk of damage or decay such as joist ends, purlins, wall plates, cut ends and rafter ends. Leaving no surface residues after treatment, it is non-staining and can be overpainted in time.

SPECIAL PROPERTIES
Brushable and injectable multi-use gel
Excellent highly penetrating preservative for the control of wood - rotting fungi and wood boring insects

• Approved under COPR 1986 for use as a wood preservative
• Low environmental hazard - no hazard symbol under COPR 1986
• Clean, easy to handle and virtually non-drip
• A clear and non-staining preservative gel
• Odourless and non-flammabl
• Permanent protection because the active ingredient does not break down
  
  DIRECTIONS FOR USE
  Treatment of wood boring insects and fungal decay:
  1. Clean all wooden surfaces using a brush or vacuum cleaner
  2. To aid brushing out on any timbers, which are very dry or remains dusty, apply a little water to the surface before the application of ACS Ecobor 20
  3. Apply a generous brush coat of ACS Ecobor 20, taking care to ensure that end grains, corners and joints are well treated. Brush apply to any surfaces exposed by cutting after initial treatment
  4. Brush the Ecobor 20 well into the surface taking care not overload the brush with the product, particularly on overhead, horizontal faces
  5. Ecobor II may be used in outdoor conditions provided that the timber treated is then protected from weathering by an appropriate coating or sealant
  6. As a surface application the gel will not penetrate through paint, varnishes or other coatings and these should be removed before treatment. Ecobor 20 can be injected through predrilled holes in areas where paint and coatings cannot be removed
  7. Clean all tools, brushes and equipment with water
  
  COVERAGE
  By brush : 1 litre to 1 - 2 m2 of timber surface. Large dimensional timbers may need more than one coat.
  By injection : Apply as necessary or until refusal through predrilled holes.
  
  SHELF LIFE & STORAGE
  Twelve months in unopened, sealed containers
  Store in original packaging, unopened or sealed in a dry, safe place
  Keep out of reach of children
  Keep away from food, drink and animal feedstuffs
  Viscosity may be reduced at elevated temperatures