Due to ADR regs on transport of flammables we can only send 25L drums of solvent product via premium rate special carrier, hence minimum FREE carriage order is 4 x 25L or ring for a quote. Alternatively, you can still collect single 25L drums at our Ulverston or Glasgow trade counters.
Kingfisher “Aquatech” is the ultimate brush applied tanking system for basements, earth retaining walls, underground garages, water tanks and more. This damp Proof tanking slurry has been trusted by structural waterproofing professionals for over 20 years.
An absolutely essential component of the Kingfisher tanking system, Anti-Sulphate (Ground Salt Neutraliser) must be applied wherever ground water has penetrated. This is because ground water contains sulphates and chlorides which degrade Tanking materials.
Kingfisher K-X11 Waterproof Admixture is a copolymer blend of latex and acrylics. This waterproofing admixture for mortar dramatically improves the characteristics of the mix, providing water resistance, adhesion, strength and flexibility to both renders and screeds.
Primarily used to seal wall to floor joints as an integral part of our Tanking system. Barrier mortar is easy to use and highly effective.
Almost instantly plugs flowing water, which may be pouring through cracks in mortar, bricks or stonework. All it takes is a handful of tank plug mortar held in place over the affected area until set. Sets in 2 minutes.
Use the Kingfisher Concrete Mixer Paddle to mix tanking slurry and renders. Use with electric drill with 10 mm chuck or larger. Size: 100 x 580mm, Hex shank (10mm) 500 to 700 rpm Max.
Kingfisher Damp Proof Paint (Damp Guard) can be applied to concrete, brick, renders and more, to help protect against water ingress. This damp proof membrane paint forms a damp guard liquid membrane and is quick drying.
Terrain TM3 Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.
Terrain Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.
Terrain TM3 Membrane is a high performance waterproofing membrane with a 3 mm stud, to prevent the penetration of water through walls and floors. This can be used as part of a Type C Cavity Drain Membrane Waterproofing System.
Terrain Plaster Plugs are used for the application of Kingfisher Mesh membrane Systems.
Terrain Plaster Plugs with seals are used for the application of Kingfisher Mesh membrane Systems.
Terrain Brick Plugs are 60 mm fixings to use when applying membrane systems to walls.
Terrain Fibre Tape is used to join waterproof plaster membranes together, and enable direct plaster or dot-and-dab application on top.
Terrain Corner Strip Tape is used to seal membranes at walls and floors and to fix perimeter drainage channels in place.
Terrain 50mm Outlet to take water from the waterguard
The Terrain Waterguard Connector Piece is a push fit joint section that allows all channel sections to connect together to form a seamless passage for water to flow and also helps inhibit lime build up. This also helps reduce movement at jointing sections.
The Terrain Extended Jetting Eye has been designed to allow cleaning and inspection of the channel system waterguard or floor drain.