Checkout: £0.00
Waterproof your basement with our range of quality membrane products including; waterproof membranes, brick plugs and plaster membrane. Waterproof membranes are a simple and quick method of damp proofing properties. They isolate damp walls and salt contaminated walls without effecting your walls finish.
We understand that every project has its own specific challenges so we offer full technical support and backup by telephone and onsite. One of our team will be happy to discuss your requirements, just get in touch.
Due to ADR regs on transport of flammables we can only send 25L drums of solvent product via premium rate special carrier, hence minimum FREE carriage order is 4 x 25L or ring for a quote. Alternatively, you can still collect single 25L drums at our Ulverston or Glasgow trade counters.
phone01229 869100
Terrain TM3 Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.
Terrain Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.
Terrain TM3 Membrane is a high performance waterproofing membrane with a 3 mm stud, to prevent the penetration of water through walls and floors. This can be used as part of a Type C Cavity Drain Membrane Waterproofing System.
Terrain Plaster Plugs are used for the application of Kingfisher Mesh membrane Systems.
Terrain Plaster Plugs with seals are used for the application of Kingfisher Mesh membrane Systems.
Terrain Brick Plugs are 60 mm fixings to use when applying membrane systems to walls.
Terrain Fibre Tape is used to join waterproof plaster membranes together, and enable direct plaster or dot-and-dab application on top.
Terrain Corner Strip Tape is used to seal membranes at walls and floors and to fix perimeter drainage channels in place.
Terrain 50mm Outlet to take water from the waterguard
The Terrain Waterguard Connector Piece is a push fit joint section that allows all channel sections to connect together to form a seamless passage for water to flow and also helps inhibit lime build up. This also helps reduce movement at jointing sections.
The Terrain Extended Jetting Eye has been designed to allow cleaning and inspection of the channel system waterguard or floor drain.
