Basement Waterproofing

Kingfisher “Aquatech” is the ultimate brush applied tanking system for basements, earth retaining walls, underground garages, water tanks and more. This basement tanking slurry has been trusted by structural waterproofing professionals for over 20 years.

An absolutely essential component of the Kingfisher tanking system, Anti-Sulphate (Ground Salt Neutraliser) must be applied wherever ground water has penetrated. This is because ground water contains sulphates and chlorides which degrade Tanking materials.

Kingfisher K-X11 Waterproof Admixture is a copolymer blend of latex and acrylics. This waterproofing admixture for mortar dramatically improves the characteristics of the mix, providing water resistance, adhesion, strength and flexibility to both renders and screeds.

Primarily used to seal wall to floor joints as an integral part of our Tanking system. Barrier mortar is easy to use and highly effective.

Almost instantly plugs flowing water, which may be pouring through cracks in mortar, bricks or stonework. All it takes is a handful of tank plug mortar held in place over the affected area until set. Sets in 2 minutes.

Ideal for mixing tanking slurry and renders. Use with electric drill with 10 mm chuck or larger. Size: 100 x 580mm, Hex shank (10mm) 500 to 700 rpm Max

Where space is at a premium and there is minimal risk of very high flows of water through the structure, the 3mm deep dimples offer a perfect combination of waterproofing and slim line design. Available with “mesh” for direct application of plaster finis

Made from tough 0.7mm gauge HDPE, the 508 range has an 8mm dimple profile which makes it perfect for internal waterproofing of retaining walls, without the need for extensive surface preparation. Rapid installation is possible using the “Multi-plug” as a

The multiplug is designed to achieve a firm fix in a variety of soft or otherwise imperfect surfaces and its integral rubber sealing grommet ensures that water cannot pass through the fixing. The multiplug doubles as a “rawl plug” accepting a 5mm screw,

Sealing Rope is used to form a seal at the overlap of adjacent sheets of membrane when neither a flange joint or stud in to stud hase been made. Sealing Rope is also used around protrusions through the membrane such as pipes.

Overtape is used to create single sided tape joints, as an over-tape to seal butted or overlapped joints and also to seal around protrusions through the membrane.

Mesh Tape is a self-adhesive butyl rubber sealing tape with a fleece finish which is used where a surface 'key' for plastering or rendering over is necessary. Used to join any of the meshed damp proofing membranes or below ground as an over tape where th

Clearly any moisture that gathers in the air gap behind the membrane will want to run down to floor level. To accommodate this, form a channel around the perimeter of the room, lay in pea gravel and bed the “Basedrain” into the pea gravel.

Kingfisher Damp Proof Paint (Damp Guard) can be applied to concrete, brick, renders and more, to help protect against water ingress. This damp proof membrane paint forms a damp guard liquid membrane and is quick drying.