Membranes

Terrain TM3 Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.

Terrain Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.

Terrain TM3 Membrane is a high performance waterproofing membrane with a 3 mm stud, to prevent the penetration of water through walls and floors. This can be used as part of a Type C Cavity Drain Membrane Waterproofing System.

Terrain Plaster Plugs are used for the application of Kingfisher Mesh membrane Systems.

Terrain Plaster Plugs with seals are used for the application of Kingfisher Mesh membrane Systems.

Terrain Brick Plugs are 60 mm fixings to use when applying membrane systems to walls.

Terrain Fibre Tape is used to join waterproof plaster membranes together, and enable direct plaster or dot-and-dab application on top.

Terrain Corner Strip Tape is used to seal membranes at walls and floors and to fix perimeter drainage channels in place.

Terrain 50mm Outlet to take water from the waterguard

The Terrain Waterguard Connector Piece is a push fit joint section that allows all channel sections to connect together to form a seamless passage for water to flow and also helps inhibit lime build up. This also helps reduce movement at jointing sections.

The Terrain Extended Jetting Eye has been designed to allow cleaning and inspection of the channel system waterguard or floor drain.