Basement Tanking

Kingfisher Aquatech Tanking Membrane is a professional-grade waterproof tanking slurry for effective basement waterproofing. This brush-applied solution creates a permanent barrier against water ingress in basements, underground garages, and water tanks. It has been trusted by structural waterproofing professionals for over 20 years and has a 10-year guarantee when installed by approved applicators.

An absolutely essential component of the Kingfisher tanking system, Anti-Sulphate (Ground Salt Neutraliser) must be applied wherever ground water has penetrated. This is because ground water contains sulphates and chlorides which degrade Tanking materials.

Kingfisher K-X11 Waterproof Admixture is a copolymer blend of latex and acrylics. This waterproofing admixture for mortar dramatically improves the characteristics of the mix, providing water resistance, adhesion, strength and flexibility to both renders and screeds.

Primarily used to seal wall to floor joints as an integral part of our Tanking system. Barrier mortar is easy to use and highly effective.

Almost instantly plugs flowing water, which may be pouring through cracks in mortar, bricks or stonework. All it takes is a handful of tank plug mortar held in place over the affected area until set. Sets in 2 minutes.

Premium Damp Proof Paint: Waterproof Barrier for Interior & Exterior Walls

Kingfisher Damp Proof Paint (now available in NEW Black). It creates a powerful waterproof barrier on concrete, brick, render, and other surfaces. This quick-drying, damp-proof membrane forms an effective liquid DPM that prevents water ingress and protects against damp problems. Our premium waterproof paint provides long-lasting protection for interior and exterior walls.

Terrain TM3 Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.

Terrain Mesh Membrane is a water resistant membrane with studs forming a regular pattern on one face of the roll, and polypropylene mesh on the other side. It is tough but pliable and can be easily cut with a sharp blade to the correct size. Suitable for use above and below ground and can be rendered, plastered or dot and dab boarded on top.

Terrain TM3 Membrane is a high performance waterproofing membrane with a 3 mm stud, to prevent the penetration of water through walls and floors. This can be used as part of a Type C Cavity Drain Membrane Waterproofing System.

Terrain Plaster Plugs are used for the application of Kingfisher Mesh membrane Systems.

Terrain Plaster Plugs with seals are used for the application of Kingfisher Mesh membrane Systems.

Terrain Brick Plugs are 60 mm fixings to use when applying membrane systems to walls.

Terrain Fibre Tape is used to join waterproof plaster membranes together, and enable direct plaster or dot-and-dab application on top.

Terrain Corner Strip Tape is used to seal membranes at walls and floors and to fix perimeter drainage channels in place.

Terrain 50mm Outlet to take water from the waterguard

The Terrain Waterguard Connector Piece is a push fit joint section that allows all channel sections to connect together to form a seamless passage for water to flow and also helps inhibit lime build up. This also helps reduce movement at jointing sections.

The Terrain Extended Jetting Eye has been designed to allow cleaning and inspection of the channel system waterguard or floor drain.